Independent diagnostics, repair and preventive maintenance for Sveba-Dahlen C-Series rack ovens, including C150, C151 and C152 equipment.
Online booking opens KONGRA LLC’s Square-hosted scheduling page. Booking & card information
A rack oven combines a large heated chamber with rack rotation, airflow management, steam and door interlocks. KONGRA separates those systems before recommending work: a bake-quality complaint can come from uneven air distribution or rack movement even when the burner reaches temperature.
Uneven bake and rotation complaints are diagnosed across airflow, rotation mechanics and settings, measured temperature, and combustion rather than being assigned automatically to a burner failure.
The visit begins with the exact C-Series model and serial number, the fuel or power configuration, stored control information where available, and the symptom under a repeatable operating condition. Temperature mapping and rotation observation are compared with the control set point rather than treating the display as the only measurement.
Door and hinge condition matters to both sealing and safe operation. Sag, inconsistent closing or disturbed alignment can change chamber leakage and interlock response, so the door, hinges, gasket contact and closing action are evaluated together.
KONGRA is independent and is not affiliated with or authorized by Sveba-Dahlen. Manufacturer and model names on this page identify equipment only.
Gas, electrical and other regulated work is performed only within KONGRA's legal scope or coordinated with properly licensed independent contractors. Sveba-Dahlen and C-Series names identify equipment only.
Intervals and scope should reflect production volume, cleaning conditions and the oven's documented condition.
A C152 complaint included uneven browning, product burning more on one side and abnormal rack rotation. The documented scope included cleaning, rotation diagnostics and calibration, temperature mapping, airflow / louver correction, and burner, ignition, electrical and steam checks. The record does not establish that every item was repaired or completed, or state a final cause.
In a later completed service, KONGRA replaced two customer-supplied door hinge assemblies. The door was supported and removed as needed, then reinstalled and aligned. Closing and alignment were checked, the oven was reassembled, and a final operational check was performed. This outcome applies to the hinge service only.
During a completed Sveba-Dahlen C152 rack-oven service, two customer-supplied door hinge assemblies were replaced. The door was supported and removed as needed, then reinstalled and aligned; closing and alignment were checked, the oven was reassembled, and a final operational check was performed.
These records document real equipment and inspection findings. They may not represent completed repairs; any unconfirmed outcome is stated as such.
KONGRA evaluates Sveba-Dahlen C-Series rack ovens, including C150, C151 and C152 examples. The exact model and serial number determine the applicable service information and parts.
No. Uneven browning can involve rack movement, airflow, fans, louvers, dampers, door sealing, steam or temperature distribution. Measurements are needed before a cause is stated.
Yes. Provide the production window, cool-down access and current symptoms so cleaning, inspection, calibration and functional checks can be planned with the least practical disruption.
No. KONGRA LLC is an independent repair service and is not affiliated with or authorized by Sveba-Dahlen. The name identifies equipment serviced.